Rustam Bana\";p=\"42383 wrote:Manish,
To remove the rust use what was used for the external surfaces.
To remove the gunk you could try petrol, diesel, acetone, surgical spirit or even immerse the part/s in boiling water and then give them a good scrub.
If you clean the parts with anything other than water, make sure that the parts are completely cleaned out with water before lubing and assembly.
srkhan wrote:How about "Mobil" and "Castrol Moly Grease" inside My Diana 45 Compression Tube
snIPer wrote:I never knew that castrol manfactures Moly Grease. cool.
Users browsing this forum: No registered users and 0 guests