Lettering
-
shooter50
- Almost at nirvana
- Posts: 155
- Joined: Thu Jan 10, 2008 8:43 pm
- Location: India
Lettering
I am doing a restoration job on an old rifle. Rust has affected the exterior, can anyone help about how to restore the letering on the rifle barrel. Cleaning and polishing has smoothened out the surface but the original lettering had also gone dim.
-
art_collector
- Shooting true
- Posts: 788
- Joined: Wed Dec 27, 2006 11:53 pm
- Location: DELHI
Re: Lettering
Hi ,
Depends which city u are in. In delhi ,meerut, lucknow and kanpur etc....most of the gun smith manage it pretty well....the process is that the picture of the faint lettering is taken and fed into the computer. which then rearranges and draws the writing again.this is then etched on the barrel...so u have an exact copy of the letters as they used to be.
Depends which city u are in. In delhi ,meerut, lucknow and kanpur etc....most of the gun smith manage it pretty well....the process is that the picture of the faint lettering is taken and fed into the computer. which then rearranges and draws the writing again.this is then etched on the barrel...so u have an exact copy of the letters as they used to be.
Last edited by art_collector on Sun Feb 17, 2008 12:09 am, edited 1 time in total.
-
Mark
- Veteran
- Posts: 1147
- Joined: Sat Jun 03, 2006 10:37 am
- Location: Middle USA
Re: Lettering
Here in the States engravers can re-cut lettering.
The going rate is $10 (400 INR) per letter, hopefully it will be cheaper where you are!
You have many skilled craftsmen inyour country, if it were me that is who I would have do it.
The going rate is $10 (400 INR) per letter, hopefully it will be cheaper where you are!
You have many skilled craftsmen inyour country, if it were me that is who I would have do it.
"What if he had no knife? In that case he would not be a good bushman so there is no need to consider the possibility." H.A. Lindsay, 1947
-
shooter50
- Almost at nirvana
- Posts: 155
- Joined: Thu Jan 10, 2008 8:43 pm
- Location: India
Re: Lettering
Do u mean etching? How is it done? is it and acid etch?