Goodmorning Fellow IFG'ians,
Earlier I have enquired in this forum about problem in my IOF.32 Marklll revolver,under topicCylinder Jamming trouble in .32 IOF revolver
Later i found out that one of the screw probably Screw Pin Fixing Barrel located exactly at opposite side of the screw which I highlighted in the attached picture loosen its thread and can,t be tightened later I find that it was not tightening at all.I order to save it from misplacing,I taken it out ,I am attaching the picturee of it as well,though revolver fire without kindly guide that the malfunctioning of cylinder is due to screw ,and suggest any good(read trustworthy) gun smith near gwalior agra jhansi where I can get it fixed ,I had not fired after that as beign afraid to get screw .Please help
P.S. Moderators I tried to put the link of my previous post but can't succed kindly help.
Regards,
Digvijay Singh Tomar
Problem in .32IOF
-
sonuvecv
- On the way to nirvana
- Posts: 78
- Joined: Fri Apr 08, 2011 1:47 am
- Location: Gwalior
Problem in .32IOF
You do not have the required permissions to view the files attached to this post.
-
sonuvecv
- On the way to nirvana
- Posts: 78
- Joined: Fri Apr 08, 2011 1:47 am
- Location: Gwalior
Re: Problem in .32IOF
Attaching the pic of loosen screw
You do not have the required permissions to view the files attached to this post.
-
dr.jayakumar
- Veteran
- Posts: 1906
- Joined: Tue Apr 06, 2010 9:55 am
- Location: tamilnadu,india
Re: Problem in .32IOF
friend if you have a worn out screw change it.your pics are not clear.
regards
dr.jk
regards
dr.jk
-
sonuvecv
- On the way to nirvana
- Posts: 78
- Joined: Fri Apr 08, 2011 1:47 am
- Location: Gwalior
Re: Problem in .32IOF
Sir it is the screw no 11given in sketch
-
James_Bond
- Almost at nirvana
- Posts: 218
- Joined: Wed Dec 19, 2012 3:31 pm
Re: Problem in .32IOF
Friend kindly contact with a Experienced gunsmith.
With Regards
CODE NAME BOND, JAMES BOND LICENSE TO RKBA
CODE NAME BOND, JAMES BOND LICENSE TO RKBA