Page 5 of 5
Re: Disassembling & Reassembling Precihole Air Rifle
Posted: Fri Jul 27, 2018 11:13 pm
by Mona singh
Bro plz upload dissembling of nx 100 nitro piston air rifle
Re: Disassembling & Reassembling Precihole Air Rifle
Posted: Wed Jun 23, 2021 6:09 am
by Sasho
Please help me how to remove the barrel of precihole px100 achilles
Re: Disassembling & Reassembling Precihole Air Rifle
Posted: Wed Jun 23, 2021 9:15 am
by Rudransh
Mona singh wrote: ↑Fri Jul 27, 2018 11:13 pm
Bro plz upload dissembling of nx 100 nitro piston air rifle
Hello Mona
Remove scope if u have mount and see there are two small grub alien screws in that 11m m dovetail which can seen from top side see where barrel is pushed inside block(hope it doesn't sound bad)..remove those screws and simply u can pull out the barrel ..But first why u need to remove barrel?
Note: Before removing barrel u need to degas the gun remove the manomtr (just screw out) then loose the 8 clamp (which hold barrel and air tank) it also has three small screw which needs to loosened then proceed with barrel removing.
Hope this helped
Regards
Veerbhadra
Re: Disassembling & Reassembling Precihole Air Rifle
Posted: Wed Dec 14, 2022 4:03 pm
by ubaid
Thanks GNV for such a detailed post. It helped me a lot in understanding the trigger system.
I am using NX200.
Actually I have messed with my upper sear. As I was compressing I left the upper sear down after replacing the piston and compressed, which I could not and all the pressure came on the sear. This made the sear bend now the gun is not at all engaging (loading). And I am not able to remove the piston too. I can see the upper sear teeth blocking the piston even after lifting the sear completely up.
Your post gave an idea and the mistake I have done.
Please advise.
1. How to remove the piston.
2. Do I have to hold the upper sear up while Compressing and lower it only after fitting the piston lock?
Awaiting your response
Regards
Ubaid